2.
Press the ID button on the back of your mouse in 2 minutes then
the LED of the receiver stop to flash
3.
Once the receiver links with the mouse successfully, and then you
can use it normally, if you move the mouse or press any key on the
mouse the LED on the receiver will flash in accordance with.
If your RF Optical Mouse is disturbed from the neighboring mouse,
please repeat the procedure 1 and 2 for better performance
Important Note
To optimize the performance of your RF reception, please make
your receiver at least 8 inches (20 cm) away from electronic
devices, such as monitor, speakers or external storage devices.
Please avoid your RF optical mouse to work on a metal surface.
Metals such as iron, aluminum or copper shield the radio
frequency transmission and may slow down the response of
the mouse of cause the mouse to fail temporarily.
This RF mouse will enter power saving mode automatically and
if you don’t move the mouse for over 10 minutes then you may
have to press any key on the mouse to wake it up.
Never use the RF mouse on a glass or mirrored surface
Each time after you insert the new batteries, please reconnect
the receiver and press the reset channel button to scan for the
best performed ID.
Battery detection system and middle wheel indicator light warn
you when the battery power is low and requires replacement.
Always use Alkaline batteries ONLY. Do not mix used and new
batteries in one mouse.
When this RF Optical mouse is interfered by other RF mouse
users, please reconnect the mouse receiver and link the
communication again
For better performance, please use USB extension cable, and
put the receiver on your desk if desktop PC is used.
Using light color mouse pad is recommended.