13
P — Select Pulse Dialing
Use this command to configure the modem for pulse dialing. All subsequent
D<dial string>
commands use pulse dialing until either the
T
command or a
tone dial modifier is received by the modem. Tone dialing is the default
setting. This command does not use parameters and generates an ERROR
result code when parameters are attached to the command.
Q<value> — Result Code Control
Result codes are informational messages sent from the modem and
displayed on the monitor. Basic result codes include OK, CONNECT, RING,
NO CARRIER, and ERROR. Use the
Q<value>
Command to enable or disable result code generation by the modem. If
result codes are disabled and an invalid parameter value is entered, the
modem does not generate an ERROR result code because result codes are
turn off.
Result codes:
• OK if <value> = 0–1.
• ERROR if <value>
≠
0–1.
T — Select Tone Dialing
Use this command to configure the modem for DTMF tone dialing. All
subsequent
D<dial string>
commands use tone dialing until either the
P
command or a pulse dial modifier is received by the modem. Tone dialing is
the default setting. This command does not use parameters and generates
an ERROR result code when parameters are attached to the command.
W<value> — Result Code Option
Use this command to select the modems CONNECT message options.
Result codes:
• OK if <value> = 0–2.
• ERROR if <value>
≠
0–2.
Command
Function
W0
CONNECT result code reports DTE receive speed.
Disables protocol result codes.
W1
CONNECT result code reports DTE receive speed.
Enables protocol result codes.
W2
CONNECT result code reports DCE receive speed.
Enables protocol result codes (default).
