Hamlet HSB 12, Руководство по эксплуатации и установке

Страница: 9 / 40

9
INSTALLATION
MULTIFUEL GRATE
The grate in the HSB Boiler Stove multi fuel
unit comprises of a series of reciprocating cast
iron bars seated on a pivoted comb. All bars in
the grate are identical, but every other bar is
turned though 180 degrees, with the ends of the
bars marked ‘H’ sitting on the high sections of
the comb, and the ends marked ‘L’ sitting on the
low sections.
ASSEMBLING THE GRATE
To assemble the grate, fit the bars to the low
section of the comb first, inserting the end
marked ‘H’ into the rear channel with groove on
the underside of the bar located on the up stand
tab, then lowering end marked ‘L’ onto the low
section of the comb. (See Fig. 1)
The upper bar is fitted in a similar manner, but
with the end marked ‘L’ inserted in the rear
channel, and the end marked ‘H’ seated on the
high section of the comb. (See Fig. 2).
GRATE BAR REPLACEMENT
After extended use it may be necessary to re-
place some of the grate bars. Periodic inspection
of the bars is recommended and the removal of
any nails or wire that may be present after
burning. All grate bars in each appliance are
identical and can be easily lifted out after the
removal of the fuel retainer. Remove damaged
grate bars and replace with casting of the same
type, fitting as per instructions above. When
re-ordering replacement grate bars, see page 35
of this manual for the correct part code.
Fig. 1 Fitting the grate bars
Fig. 2 Assembled grate
HSB Boiler Stove
FIRE BED SURROUNDS
Cast Fire Bed Surrounds are supplied with your HSB
Boiler Stove and should be fitted into the retaining holes
in the rear Grate Bar Support as shown in Fig a the num-
ber of surround castings is dependant on the stove size
and is detailed on page 6.
Fig a
Fire Bed Surround location holes
in the rear grate bar support.
Fig. b
Cross sectional view of the HSB Boiler
Stove showing Fire Bed Surrounds in place.