a. Power off your PC(s), Cable/DSL modem, and the AP.
b. Locate an optimum location for the router. The best place is
usually near the center of the area in which your PC(s) will
wirelessly connect. .
d. Connect the PC(s) and each Switch/Hub on your LAN to the
LAN Ports on the AP, shown in the following figure.
1
2
1. Connecting the Access Point
WIRELESS AP ROUTER SUPER G 108 MBIT
Quick Installation Guide
Dear Customer,
thanks for choosing Hamlet. Please carefully follow the
instructions for its use and maintenance and, once this item
has run its life span, we kindly ask You to: dispose of it in an
environmentally friendly way, by putting it in the separate bins
for electrical/electronic waste, or to bring it back to your
retailer who will collect it for free.
www.hamletcom.com
Before you install the Access Point Hamlet (AP), you should have
connected your PC to the Internet through your broadband service
successfully. If there are any problems, please contact your ISP. After
that, please install the router according to the following steps. Don't
forget to pull out the power plug and keep your hands dry.
c. Adjust the direction of the antenna. Upright is a good direction.
f. Connect the AC power adapter to the AC power socket
on the AP, and the other end into an electrical outlet.
The AP will start to work automatically.
g. Power on your PC(s) and Cable/DSL modem.
h. When all of the devices boot up completely, make sure
that the AP's LEDs light as follows:
Power LED: Lit up
System LED: Flashing
Link/Act LEDs(WAN&LAN): Lit up
WLAN LED: Flashing
e. Connect the DSL/Cable Modem/Ethernet to the WAN port on the AP,
shown in the following figure:
