Hamilton HA-1000 Скачать руководство пользователя страница 6

Страница: 6 / 6

Step#17

Install foam strip to strike edge of tube opening

Step#18

Test door operation. Door should stay sealed tight

so that door seal closes against it.

when carrier arrives in teller. If the door seal leaks

on the strike side, you can adjust the position of the

Detent Mounting Block to the right.

Step#19

Adjusting Spring Plunger. 3-Ways to do so.

Step#20

Re-install Upper and Lower Switch covers.

Adjust plunger depth (In-Out)

Note: Use 10-32 x ¼ HHMS provided in kit

Adjust mounting block location (Left-Right)

to mount lower switch cover.

Adjust plunger spring tension (Rear Set Screw)

Note:

Grease the Pin end of Plunger and the steel

roller pressed in the aluminum Door Ring with
grease supplied in kit.

Содержание HA-1000

Страница 1: ...inum 1 8 Door Bearing Black Plastic 2 15 Detent Mounting Block 1 15 Spring Plunger Detent Installed in Mounting Block 1 15 10 32 x 3 8 Set Screw Installed in Mounting Block 1 15 3 32 Allen Wrench 1 15 Grease Mini tube Lithium 1 17 Foam Strip Seal 1 4 x 9 3 4 P N B6620 1 20 10 32 x 1 4 HHMS 2 Note Please retain all parts removed from unit and return using supplied UPS label ...

Страница 2: ... Chamber Cover Note Cover is sealed with silicone from factory Only needs re sealed if used in Point to Point 22 35 20 Step 3 Remove 3 Coupler Nuts holding lower frame Step 4 Remove Door Assembly including ALL rings Remove Lower Frame and spacer nuts Note New Spacer Nuts Supplied in Kit ...

Страница 3: ...be cleaned so that top Door Bearing existing screws rest flat under top plate K 17 K K 10 2 3 3 2 Step 7 Replace Upper Door Ring with part in kit Step 8 Replace upper and lower Door Bearings with New ring has cylinder retained by screw for detent parts in kit Note Make sure only one Bearing Race is used on top and bottom of door ...

Страница 4: ...ts stacked as shown in step 7 11 34 Step 11 Check rotation and vertical play of door Step 12 Re install Exhaust Chamber Cover Shim washers may need to be added to spacers Note Cover is sealed with silicone from factory installed in step 6 to free door rotation Only needs re sealed if used in Point to Point ...