Page 2
10.
Hand-tighten the upper
poles (with holes) to the
lower poles.
1.
Lay front legs (labeled "O" and "X") on the floor with the brackets
facing upward and inward as illustrated. Note: legs,when placed
on the floor should bend upward, off the floor at their top end and
the width of the unit should remain constant all the way to the top.
2.
Slide each shelf over the brackets on the legs.
The brackets
should be inside the shelves
. The largest shelf is the bottom
shelf. The top shelf has logo decal on it.
3.
Slide the two remaining legs onto the shelves as illustrated. Make
sure that the brackets are inside the shelves.
4.
HAND TIGHTEN
the top,
middle and bottom shelves
at the two corners with
square head bolt, washer
and nut (screw table
I
) as
illustrated. Please make
sure washer and nut are
together on the inside of
the leg bracket.
5.
In order to have the unit properly
aligned, stand unit upright on a
level surface. Gently rock unit
back and forth to realign and
level the unit.
TIGHTEN ALL
NUTS AND BOLTS WITH
WRENCHES AT THIS TIME.
Unit should now be properly
aligned and level. If unit is not
level at this time, repeat the
above steps before proceeding
to step 6.
7.
Lay unit on the floor. Align the holes on the
casters with the holes on the corner of the
bottom shelf. Use the hex screws
(see Screw table
F
) and tighten
the caster. Repeat the same
for the other three casters.
It is recommended you
place the locking casters
on either the right side
or left side of the unit
for safer and easier
movement of cart
through doorways, ect..
( Instructions continued on next page )
To
p
Bottom
Leg"O"
Leg"X"
Top
Middle
Bottom
Leg"O"
Leg"X"
Back of shelf
Front of shelf
Leg "X"
Leg "O"
6.
Slide the rear panel between the
middle and bottom shelf. The
bottom of the rear panel
needs to hook onto the
bottom shelf frame lip
and the top of the rear
panel needs to go in
between middle shelf lip
and the brackets.The
side panels Assembly
as same as above steps.
8.
To secure the cabinet panel, use the machine screws (see screw
table
N
) to tighten the cabinet panels to the frame poles as shown.
There are two screws on each side.
9.
Install the two doors onto the frame with two machine screws
(see screw table
N
) on each side.
Do not tighten completely
at this time.
Adjust the doors to make sure they close and lock
OK. Tighten all screws.
Upper pole
Lower pole