4
2
1
3
4
7
8
5
6
REMOTE CONTROL HANDSET
1. IR Transmitter
2. Standby / On Button
- ON and OFF the system
. Function Button
- Selects source input, iPod
®
and AUX IN
4. Skip
Button
- Skip or fast backward while iPod
®
is playing
5. Button
- Increases volume level
6. Volume – Button
- Decreases volume level
7. Play/Pause Button
- Play and Pause iPod
®
play
8. Skip
Button
- Skip or fast forward while iPod
®
is playing
REMOTE CONTROL BATTERY INSTALLATION
1. Slide the battery compartment out.
2. Install 1x CR202 battery (V) into the remote,
paying attention to the polarity diagram in the battery
compartment.
. Replace the battery compartment.
Note :
1. Weak batteries can leak and severely damage the
remote control unit.
2. This unit comes with a battery. Pull out the insulation sheet to begin use.
BATTERY PRECAUTIONS
Follow these precautions when using battery in this device:
1. The batteries (battery pack or batteries installed) shall not be exposed to excessive
heat such as sunshine, fire or the like.
2.
Do not attempt to recharge, short-circuit, disassemble, heat or throw the battery into a fire.
. If the device is not to be used for a long period of time, remove the batteries to prevent
damage or injury from possible battery leakage.
4. Do not try to recharge batteries that are not intended to be recharged as they could
overheat and rupture. (Follow battery maufacturer’s directions.)
5. Dispose of batteries properly in accordance with local laws.
AC Adapter Operation
1. Insert the DC plug, at the end of the adapter cord, into the DC input jack on the product.
2. Plug the AC adapter into an AC power outlet. Only use with the recommended
9V - 2.2A AC adapter and make sure the local voltage corresponds to adapter’s required
AC input voltage.
MAIN POWER SUPPLY
Check that the power voltage as shown on the type plate corresponds to your local power
voltage. If it does not, consult your dealer or service organization.
IPB125 HJ580SA eng 09.indd 4
2009/4/20 11:2:57 AM