Hamilton Beach HBWC112-SSWH, Инструкция по эксплуатации

Страница: 4 / 14

OPERATION
●
Ambient temperature
●
Temperature 0-35°C
●
Atmosphere 86-106 kpa
●
VOLTAGE:115V/60HZ
●
Position the water cooler on the horizontal, structurally sound ground. Leave an
adequate open space (10-20 cm) behind the water cooler for good ventilation.
●
When using the bottles holding ultra-pure water, distilled water or space water with
the so-called clever lid, tear off the hygienic labels on the lid. Place the bottles at the
intake, then the core of water guard will automatically open the valve and seal it in
the meantime, when moving the bottles, the valve will also seal automatically to
avoid any possible oozing.
●
Push the hot water valves, bubbles are generated inside the bottle, indicating that
water is flowing into hot water and cold water tanks, keep pressing the hot water
valve until water flows out, dispensing cold water required need no particular
adjustment.
●
Caution: Do not connect the electrical power plug until water comes out of the hot
water tap.
●
After water is flowing out from the hot tap, then we can open the switch at the back
side.
●
Turn the heating switch on, the red indicator is on and the heating system starts
working. When the hot water comes up (86-95°C) or so, the red light goes off, the
heating system stops working, and it is on a warm keeping status.
When the hot water temperature is lower than 85°C, the heating system will resume
working again automatically.
●
Turn on the cooling switch, the green indicator is on and the cooling system starts
working. When the cold water falls down to 5-10°C (for compressor-cooling), the
green light goes off, the cooling system stops working, and it is on a cold keeping
status.
When the cold water temperature goes up to a set degree, the cooling system will
resume working again atomically.
●
Since the temperature has already been adjusted before leaving the factory, it is
unnecessary for customers to set the temperature.
●
If device is not applied for a long time, after the hot water cools down, please
remove the power plug and revolve the drain the rest water in the hot tank then
tighten the cap open the cold water tap to drain the rest water in the cold tank.
●
If there is no water flowing from cooling tap, please shut down the cooling switch until
there is water flowing out.