9
Iron won’t
heat
PROBLEM
THINGS TO CHECK
Water is
leaking
Iron
won’t
steam
Leaves
spots
• Is the iron plugged in and the outlet working?
Check the outlet by plugging in a lamp.
• Is the Temperature Control Dial turned to a
fabric setting?
• If automatic shutoff model, is the Reset Button
Light illuminated? If not, press to reset.
• Do not overfill the water tank.
• If steam ironing, is Adjustable Steam Knob in a
steam position, the Temperature Control Dial in
the steam range, and did the iron have enough
time to preheat?
• If dry ironing, make sure the Adjustable Steam
Knob is in the DRY IRON position.
• Check the water level.
• Is the Adjustable Steam Knob in a Steam
position?
• Has the iron had enough time to preheat?
• ALWAYS empty the water tank of the iron
after using. Water left in the tank may discolor
clothing and soleplate.
• If the iron cord should become twisted, unplug
iron and let cool. Hold iron cord in the middle
of entire length. Let plug and iron dangle freely
until cord uncoils. This will extend the life of
your iron cord.
Twisted
cord
Troubleshooting
8
Caring and Cleaning
Iron Storage
1.
The water tank of your iron should be emptied after each
use. Turn Temperature Control Dial to Off. Unplug the iron
and hold over a sink. Slowly tilt pointed end of iron down
over sink. Water will run out of water tank opening.
2.
After iron has completely cooled, fully retract the cord into
the iron and store in an upright position. Do not store iron
laying flat on soleplate.
Soleplate
1.
Never iron over zippers, pins, metal rivets, or snaps, as
these may scratch the soleplate.
2.
To clean occasional build-up on the soleplate, wipe with
a sudsy cloth. Do not use abrasive cleansers or metal
scouring pads.
3.
Always store iron upright in the heel rest position.
Self-Clean
To keep the steam vents clear of any build-up, follow these
instructions each time you iron using steam.
1.
Fill iron with water then plug in iron.
2.
Turn Temperature Control Dial to Linen setting and let iron
heat for 2 minutes.
3.
Turn Temperature Control Dial to Off. Unplug iron and hold
over a sink with the soleplate facing down.
4.
Turn Adjustable Steam Knob to CLEAN and gently pull the
Knob up. Hot water and steam will flow out of steam vents.
Allow all water to drain from iron.
5.
Press and turn Adjustable Steam Knob counterclockwise
to reset then let cool and store.
840117300 Ev01.qxd 10/15/03 4:42 PM Page 8
