In this position (lower), the output video signal is inverted with regard
1 0 . 3 M 2 5 0 4 V I D E O
t o input intensity as indicated below.
INVERTER
Inversion
The
VIDEO
INVERTER option comes completely adjusted and ready for
use.
Installation:
1.
T u r n
POWER
s w i t c h
OFF
on the Camera Control Unit (CCU).
2. U n p l u g the CCU power supply cord.
3. U s i n g a small Phillips screwdriver, loosen the 4 screws on the side
of the CCU and remove the cover.
4. I n s e r t the M 2 5 0 4 option card i n t o the connector labeled J C
I N -
VERTER
as illustrated in the figure below.
5. R e p l a c e the CCU cover making sure that the air vent is located on
the left and tighten the 4 holding screws.
T
h
e
EXTERNAL SYNC option comes completely adjusted and ready for
10.4 M 2 5 0 5 u s e .
EXTERNAL
SYNC
Installation:
1.
T u r n
POWER
switch
OFF
on the Camera Control Unit (CCU).
2. U n p l u g the CCU power supply cord.
3. U s i n g a small Phillips screwdriver, loosen the 4 screws on the side
of the CCU and remove the cover.
4. I n s e r t the M2505 option card into the connector labeled
JD
SYNC
as illustrated in the figure below.
