8
9
Panic
Arm Home
Arm Away
Disarm
Step 4:
You will hear a long beep and the zone LED stops flashing. The remote
control is now programmed to the Control Panel. MUTE INPUT DC 12V LEARN
ALERT CHIME OFF
Note:
You may program 1 remote control to one zone.
If you have multiple remote controls, you need to program them into different
zones. (one per zone)
3. OPERATION
The remote control can be used to arm, disarm, activate the alarm instantly.
Arm Away
- Pressing the Arm Away button on the keychain remote will arm
the system in Away mode, which will result in a 45-second exit delay. Arm
LED will flash.
Arm Home
- Pressing the Arm Home button on the keychain will arm the
system in Home mode. Arm LED will be steadily on instantly.
Disarm
- Pressing the disarm button on the keychain remote will disarm the
system instantly. Arm LED will also be off.
Panic
- Pressing the panic button will cause the siren to sound instantly.
4. BATTERY REPLACEMENT
The battery of the keychain remote (Alkaline, Type 23A, 12V) needs to be
replaced when either one of the followings occurs:
1. The LED on the keychain doesn’t flash or on when a key is pressed; or
2. The operating range starts to decrease.
To replace the battery:
1. Undo the two screws on the back of the transmitter.
The bottom case will then come off.
2. Using a small screwdriver or pen, pry out the old
battery from one end.
3. Place the new battery in position. A diagram in the
battery compartment indicates which end is positive
and which is negative.
4. Close the battery cover and reinsert two screws
Registration and Safety Certification/General Information
This device bears the CE symbol as specified by the provisions of Directive R & TTE
(1999/5/EC).
Hama GmbH & Co. KG hereby declares that this device is in compliance with the basic
requirements and other relevant guidelines and regulations of the 1999/5/EC guideline.
You will find the declaration of compliance and declaration of conformity in the
Internet at http://www.hama.com
Содержание RC200
Страница 1: ......
