Hama Quad Switch LNB, Руководство по эксплуатации

Страница: 6 / 10

4
G Operating instruction
Thank you for choosing a Hama product.
Take your time and read the following instructions
and information completely. Please keep these
instructions in a safe place for future reference. If
you sell the device, please pass these operating
instructions on to the new owner.
1. Explanation of Warning Symbols and Notes
Note
This symbol is used to indicate additional
information or important notes.
2. Package Contents
• Quad switch LNB
• These operating instructions
3. Safety Notes
• This product is not intended for use by persons,
including children, with limited physical, sensory
or mental abilities or lacking in experience or
knowledge, unless they are supervised by a person
responsible for their safety or have been instructed
on how to use the product.
• Ensure that you do not mount any faulty or
damaged products/components.
• Make sure that cables do not pose a tripping
hazard or block emergency exits.
• Do not drop the product and do not expose it to
any major shocks.
• Do not attempt to service or repair the product
yourself. Leave any and all service work to qualified
experts.
• Do not open the device or continue to operate it if
it becomes damaged.
• If in doubt, have this product mounted by a
qualified technician - do not attempt to mount it
yourself!
• Once you have mounted the product and the
attached load, check that they are sufficiently
secure and safe to use.
4. Mounting
• Place the LNB in the mount (fig. 1). Make sure that
the coaxial connections are on the bottom and the
receiver is pointed towards the satellite dish.
• Push the LNB in the direction indicated by the
arrow (fig. 2) as far as it will go towards the
mounting clamp. In most cases, this adjusts the
phase centre to match the satellite dish.
• Screw the top half of the mount tight (fig. 2) to
permanently fix the LNB in place. Tighten the
screws.
• Connect the coaxial cable to the coaxial connec-
tion on the LNB (fig. 3). Turn the F-connector as
far as it will go and then pull the weatherproof
cap over it.
Note
During first-time installation or after replacing an
LNB, you should align the satellite dish and the
LNB using a suitable satellite measuring device
in order to ensure optimal reception. To maximise
the horizontal and vertical signal reception, you
can turn the LNB in accordance with the angle
scale and move it forward. To do so, you need to
loosen the holder (fig. 2) and afterwards properly
tighten it again.
5. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability and
provides no warranty for damage resulting from
improper installation/mounting, improper use of
the product or from failure to observe the operating
instructions and/or safety notes.