Hama EWS Series, Руководство по эксплуатации

Страница: 7 / 10

5
6.2 Basic and manual settings
Automatic setting using the DCF signal
(radio- controlled clock)
•
When the base station has been switched on for the first
time and successful transmission has been established
between the base station and the measuring station, the
clock will automatically search for the DCF signal. During
the search, the radio symbol for DCF reception flashes.
Display (8) Searching for the DCF signal
Display flashing
Active
Displayed continuously
Successful – signal is being received
Not displayed Deactivated
•
If the station still does not receive a signal, press and hold
the
DOWN
button (13) until the radio symbol begins
to flash, to start the manual search for the DCF
signal.
Manual settings
• Press the
SET
button (11) to make the following
settings in order:
• Time zone
•
Year
•
Calendar month
• Date
• Hour
•
Minute
•
12/24-hour format
• To select individual values, press the
UP
button (12) or
the
DOWN
button (13) and confirm each selection by
pressing the
SET
button (11).
•
Press the
SET
button (11) to adopt the set value
displayed and to skip.
• If you do not make an entry for 20 seconds, you
automatically exit the setting mode.
•
Press and hold the
DOWN
button (13) again for
approximately 3 seconds to stop the manual search.
• Hold the
UP
button (12) or the
DOWN
button (13)
to select the values faster.
Not
e
•
The clock automatically switches to summer time.
Note
– Summer time
•
The search process takes about 3 minutes. If the search
fails, it ends and is repeated at the next clock hour. The
radio symbol ( ) goes out.
• It is not possible to manually set the time and date
during the search for the DCF signal.
• The clock automatically continues to search for the DCF
signal on a daily basis (between 1 am and 5 am) to
correct any deviations.
•
If the signal is received successfully, the manually set
time and date are overwritten.
Note
– Time settings
•
The DCF signal can be received over long distances, but
always transmits the current Central European Time in
Germany. Please note that for countries with a different
time zone, you must set the time difference manually.
•
If you are in Moscow, for example, the time is 3 hours
later than in Germany. This means that you should
set +3 for the time zone. The clock then sets the time
automatically to 3 hours ahead after receiving the DCF
signal or according to the manually set time.
Note
– Time zone