Hama DR1500BT, Руководство по эксплуатации

Страница: 9 / 36

7
6.9 Connecting and playing music files in Bluetooth
mode
Note – Bluetooth connection
• Also follow all instructions and notes regarding
Bluetooth in the operating instructions for the
device you wish to connect. The exact process for
establishing a Bluetooth connection between the radio
and your device can vary.
• Ensure that your device supports the A2DP Bluetooth
profile.
• Take care that Bluetooth is activated on your device.
• Ensure that the radio and your device are not more than
1m apart from each other.
• Press MODE repeatedly until Switch to BT appears on
the display. The radio switches a few seconds later into
the Bluetooth Pairing mode.
• Start the search for Bluetooth devices on your device in
the Bluetooth settings. If the radio is found it will display
on your device as BT speakerN . If you are asked for a
key for pairing, enter 0000.
• Select BT speakerN on your device and run the pairing
process. This may take several seconds. The radio signals
successful pairing by means of a signal tone and by
displaying - Icons on the display.
• After successfully pairing, press SCROLL/OK ►II or begin
playback on your device.
• To pause playback press SCROLL/OK ►II again or the
corresponding pause or stop buttons on your device.
• In order to rewind or forward through music files during
playback press ►►I or I◄◄ , or the corresponding
buttons on your device.
Note – Mobile phones
• Some mobile phones interrupt the Bluetooth
connection when receiving calls. This is not a problem
with your radio, but rather your mobile phone‘s
specific way of behaving during Bluetooth operation,
which can vary by manufacturer.
7. Additional functions
7.1 Display light
This radio has a display light that can be dimmed to three
different levels.
• Press BACKLIGHT repeatedly until the desired level of
brightness is reached.
7.2 Displaying firmware version of radio
Press and hold INFO longer than 2 seconds in order to
display the current firmware version of your radio.
7.3 Reverting to factory settings
•
Connect the enclosed power cable to the 220V input of
your DAB/FM radio.
• Connect the power cable to a properly installed 220V
power socket.
• Press STANDBY to switch on the radio.
• Press and hold MENU until the display shows the
message ‚ Press SELECT to confirm reset ‘.
• Press SCROLL/OK ►II . The display shows the message
‚ Restarting… ‘ and then goes into standby mode.
• Switch on the radio as described in section 4.1 and
perform the subsequent steps for setup and station
search.
Warning
• All saved DAB and FM presets are wiped when
reverting to factory settings.
7.4 Headphone connection
On the rear of the radio is a headphone connection (14),
which is suitable for headphones with a 3.5mm stereo jack.
When headphones are being used the built-in speakers are
deactivated automatically.
Warning - high volume
• Always keep the volume at a reasonable level. Loud
volumes, even over short periods, can cause hearing
loss.