Hama 135810, Руководство по эксплуатации

Страница: 3 / 6

G Operating instruction
Thank you for choosing a Hama product.
Take your time and read the following instructions and
information completely. Please keep these instructions in
a safe place for future reference.
1. Explanation of Warning Symbols and Notes
Warning
This symbol is used to indicate safety instructions or
to draw your attention to specific hazards and risks.
Note
This symbol is used to indicate additional information
or important notes.
2. Safety Notes
• Use the product for its intended purpose only.
• Protect the product from dirt, moisture and overheat-
ing, and only use it in a dry environment.
• When using this product, observe the applicable local
traffic laws and regulations.
• Do not drop the product and do not expose it to any
major shocks.
• Keep the packaging material out of the reach of
children due to the risk of suffocation.
• Dispose of packaging material immediately according
to locally applicable regulations.
• Do not modify the product in any way. Doing so voids
the warranty.
3. Montage
Note
• Before mounting the holder, check the installation
options in your vehicle. If in doubt, consult
the manual for your vehicle or contact the
manufacturer.
• Never apply force when using the product or
during installation.
Warning
• Take care that components such as airbags, safety
areas, controls, instruments, etc. and visibility are
not blocked or restricted.
• Do not allow yourself to be distracted by the
product, for example when driving a vehicle or
operating sports equipment. Always pay attention
to the surrounding traffic and your environment.
• Remove the protective film from the suction cup and
position it on a clean and flat surface (e.g. window
pane).
• If the suction cup holder is to be attached to a rough
or uneven surface (e.g. a dashboard), an adapter plate
is optionally available.
• Push the locking lever (Pic.1 – 1) to fasten the suction
cup.
• Open the clamping device (Pic.1 – 4) to position the
carrying arm.
• Close the clamping device to lock this position.
• To release the suction cup from the surface, pull the
lateral slides in the direction of the arrow. (Pic.1 – 2)
Then gently pull the flap to completely release the
suction cup. (Pic.1 – 3)
• The ball joint allows the holder to be rotated 360°. To
set the ideal viewing angle, undo setting wheel, adjust
the holder and tighten the setting wheel again. Always
ensure that the setting wheel is firmly tightened before
beginning your journey.
Clip system (A) / 4-hook/hole clip system (B) (Pic.2)
• Set the recess or recesses of the holder onto the
bracket.
• Move the holder up or down until it clicks into place
or is seated firmly.