Hama 00014169, Руководство по эксплуатации

Страница: 6 / 16

3
6.4 Manual station search
• Search for a free frequency (noise without signal fragments)
on your car radio.
• Set the same frequency on the FM transmitter. To do this,
press the button (5) for approx. 2 sec. until the frequency
indicator on the display (3) starts flashing.
• Then set the desired frequency by pressing the
<
or
>
keys.
• The FM transmitter always automatically stores the last
frequency set.
Note - Automatic standby
• The FM transmitter switches off automatically after
approx. 50-60 sec. without a music signal or key input
(standby).
• The FM transmitter is reactivated by a music signal or
key input.
6.5 Charging function
The FM transmitter has two USB charging sockets. These supply
the charging currents specified in Point 9 of the technical data.
Note - car battery
With some vehicles, it can happen that power continues to
be supplied even though the ignition has been switched off.
You should therefore disconnect the product from the line
connection when not in use to protect your car battery from
being drained.
Note - connecting devices
• Before connecting a device, check whether it can be
adequately supplied with the charger's current capacity.
• Ensure that the total current consumption of all the
connected devices does not exceed 3000 mA.
• Note the instructions in your device's operating manual.
• Disconnect all cable and mains connections after use.
Note – Power Delivery/ QC 3.0, 2.0
• Plug & GO: no additional software required, simply plug
in and start:
Thanks to Power Delivery / QC 3.0, 2.0, the voltage and
power are adjusted automatically.
• Be aware that, for efficient and optimised charging, your
terminal device must support the PD (Power Delivery)/
QC 3.0, 2.0 function.
• If you have a large number of PD/QC-enabled devices with
different firmware updates, it may be that the function is
not fully supported.
6.6 Hands-free function
• The FM transmitter has an integrated hands-free function
thanks to the built-in microphone.
• When a call comes in, the device automatically switches from
music mode to hands-free mode. In this case, simply press the
button to answer the call.
• To end the call, press the button again.
• If you press the button twice in succession, the last
number dialled is automatically called.
7. Care and maintenance
Only clean this product using a lint-free, slightly damp cloth and
do not use any harsh cleaners.
Note
Disconnect the device from the mains before cleaning and
during prolonged periods of non-use.
8. Warranty disclaimer
Hama GmbH & Co KG assumes no liability and provides no
warranty for damage resulting from improper installation/mount-
ing, improper use of the product or from failure to observe the
operating instructions and/or safety notes.
9. Technical data
FM transmitter with
Bluetooth function
Bluetooth technology
Bluetooth
® v5.3
Input voltage 12 – 16 V
Input current 4A
Output voltage and current
at USB 1 (marked with
symbol)
5V 3A
9V 2.22A
12V 1.67A
Output current USB 2
(marked with QC 3.0)
5V 3A
9V 2A
12V 1.5A