Ham MFJ-413, Инструкция по эксплуатации

Страница: 5 / 16

MFJ-413/417 Instruction Manual Pocket Morse Code Tutor
3
"
SPEED = 4 WPM
#
SPEED = 5 WPM
$
SPEED = 6 WPM
%
SPEED = 7 WPM
• • •
∑
SPEED = 60 WPM
Code requirement is 5 WPM for the Novice and the Technician. Both General
and Advanced levels have a code requirement of 13 WPM. Extra class has a 20
WPM requirement.
Group Button
The Group button adjusts the number of characters for a character group. The
options are random length group or fixed length group ranging from one to eight
characters per group. The random length generates variable length of up to eight
characters per group. This option is only applicable to character sets.
To change the group length, press the Group button to increase the group length.
Each button press increases the group length by one character and is confirmed
with a beep.
!
GROUP = RANDOM
"
GROUP = 1-CHARACTER
#
GROUP = 2-CHARACTER
$
GROUP = 3-CHARACTER
%
GROUP = 4-CHARACTER
&
GROUP = 5-CHARACTER
'
GROUP = 6-CHARACTER
(
GROUP = 7-CHARACTER
)
GROUP = 8-CHARACTER
Set/Play Button
The Set/Play button selects one of the characters, words, or QSOs set and plays
it using the current settings. To select a set, press the Set/Play button. Each
button press selects the next set as listed below as the active set and is confirmed
with a beep. Playback starts if the button is released for more than one second;
therefore, pause between button presses must be less than one second. For
example, to play the third set
only , press and release the Set/Play button three
times. Approximately one second after the last button release, the Tutor starts
sending code with the selected set. Holding the Set/Play button down for one
second enables the Combine mode (discusses next).
At any time during sending or halting for interactive feedback, press and hold the
Set/Play button for one second until there's a beep to repeat the current session.
Replaying a session allows you to recopy the same code to check your accuracy.