In order for the device to work, you will need a
Wi
-
Fi router
with an internet connection. If your router doesn't support
WPS
, you will need a smartphone with
Android
or
iOS
for the setup procedure.
Device installation should be performed only by professionals (such as electricians) with the electri-
cal power disconnected
1.
Disconnect electrical power.
2.
(optional) Install an
S0
module.
3.
Make the connections like shown on the diagram on the right.
4.
Check your connections and restore electrical power.
5.
Check that the device works properly by pressing the
on/off button
a few times. The
red LED
should
respond and the connected load should be
activated/deactivated
. The
red LED
is lit when the output
is activated.
6.
Connect the device to the
Wi
-
Fi
router. If your router supports
WPS
, then push the
WPS
button to
enable the
WPS
function. Press and hold the on/off button on the device for a few seconds until you
see the
green LED
blink. If WPS is not supported the use the
Android
or
iOS
app , choose the
Setup
Device
option and follow the instructions there.
7.
Check the device is connected to the router and the internet by looking at the
green LED
. If the device is connected to
the HAM platform, the
green LED
should be lit.
8.
Connect to
https://hamsystems.eu
or open the smartphone app. If you don
’
t already have an account, create one.
9.
Using the option
Claim device
, input the device key that came with your device.
10.
If the previous step was successful and the device is connected to the internet, then you will be redirected to the a
screen where you can control your device.
11.
Check that the installation is successful by turning on/off the device output through the screen.
In case there is an issues on the steps 5
-
10, try pushing the
Reset
button and wait a few seconds.
SETUP INSTRUCTIONS
