Halytech microSpider2 Environmental, Быстрый старт, Страница: 4 / 12

4
Connecting the Antenna and Power
1. Take the pre-greased O-ring out of the plastic bag and feed the antenna and
power cables through it.
(Fitting the O-ring into the case will be discussed in the next section.)
2. Connect the antenna by pressing the flying lead connector squarely onto the
gold circuit board antenna connector until it "clicks-in".
Connect the battery lead by pushing it onto a free battery connector on the circuit board
(usually BATT1) until it clicks into place.
3. EXTERNAL ANTENNA UNITS ONLY
These units are fitted with an SMA male connector on the top of the case.
Once the external antenna is connected, it is recommended to seal the
connection by using self-vulcanising rubber tape.