5
EcoloAir Installation Manual
EA
OMSI/0620
09/re
v1/EN
ECOLO ODOR CONTROL
To replace a 5 gallon/22 liter bottle of odor solution (“Scentry”)
1. Open enclosure cabinet door by unscrewing the two lock bolts.
2. Screw the cap off the empty bottle/reservoir.
3. Pull the dip tube assembly out of the empty bottle.
4. Remove the empty bottle from the cabinet
5. Refill bottle with concentrate and mix well as per instructions or refill with “ready to use, pre-mixed
solution.
6. Place the bottle in the cabinet.
7. Put the dip tube assembly into the new bottle. Make sure the dip tube reaches the bottom of the
bottle.
8. Place cap on bottle neck and make one turn. DO NOT TIGHTEN (Option: place low level probe in bottle).
9. Close the cabinet door and lock with locking bolts.
NOTE: The standard EcoloAir unit comes with the Ecolo Odor Control pre-mounted and installed.
SCHEMATIC WIRING DIAGRAMS
For field wiring diagrams and field connections refer to Halton’s shop drawings shipped with unit or contact
factory.
Additional copies of shop drawings are available on request.
FAN SECTION
Important note:
Before starting the fan unit, remove fan isolator hold down brackets. The brackets are used for shipping
purposes only. When the brackets are removed the fan should float freely on the spring isolators.
START UP NOTICE
The unit is now ready for start-up. The start up and initial check out are to be performed by an “authorized”
service agent. If the start-up is performed by someone other than an “authorized” agent the Warranty is null
and void.
Halton agent must have a minimum notice of five (5) days to schedule start-up. Should the equipment not
be ready for start-up at the specified time any additional expenses incurred will be charged to the dealer who
purchased the equipment.
For any questions please contact Halton Service Network at (270) 237-5600 for the U.S. and (905) 624-0301 for
Canada.
