7(8)
equipment uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
methods:
•
Increase the separation between the equipment and the receiver.
•
Connect
the equipment into an electrical outlet on a circuit different from that
which the radio receiver is connected
•
Consult the dealer or and experienced radio/TV technician for
help
FCC Caution
•
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate this equipment.
•
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Canadian Department of Communications
Radio Interference Regulations
EQUIPMENT SPECIFICATION
RF Interface:
•
Frequency range:
2402
– 2483 MHz
•
Max RF output power:
+4 dBm
•
Type of antenna:
PWB strip line (IFA)
•
Ant. frequency band:
2402
– 2483 MHz
•
Antenna gain:
-1.0 dBi
PRODUCT AND SAFETY INFORMATION
•
Thingsee TAG is indented for capturing specified motion and environment data.
Use the device for its indented use only.
•
For optimal performance do not operate the device below -20°C and above
+60°C
•
Failure to comply with the instructions may cause damage to the device.
•
The socket-outlet for the power source shall be installed near the equipment and
shall be easily accessible.
