halstrup-walcher PSE3**PN series, Инструкция по эксплуатации

Страница: 14 / 35

Instruction Manual PSx3xxPN
14
Name Par.
Number Function Type/
Range Back
up Delivery
State R/W
Parameter group “velocity”
target speed 53 maximum rpm to be used for positioning
runs
value in rpm *)
16 bit yes *) R/W
target speed
for manual
run 56 maximum rpm to be used for manual runs
value in rpm *)
16 bit yes *) R/W
speed limit
for aborting
run 57 value in % of the target speed 30...90
16 bit yes 30 R/W
acceleration 58 value in rpm per sec. *)
16 bit yes *) R/W
deceleration 59 value in rpm per sec. *)
16 bit yes *) R/W
Parameter group “torque”
maximum
start-up
torque 63 value in cNm *)
16 bit yes *) R/W
maximum
torque 64 Applies after completion of start phase
(during start phase the value Par. 63
applies); value in cNm *)
16 bit yes *) R/W
maximum
holding
torque at end
of run 65 value in cNm *)
16 bit yes *) R/W
maximum
holding
torque 66 maximum holding torque at standstill in
cNm (after completion of the phase “max.
holding torque at end of run”) *)
16 bit yes *) R/W
Parameter group “time”
time elapsed
until speed
falls below
speed limit
for aborting
run 70 value in msec
(see also Par. 57) 50...500
16 bit yes 200 R/W
time period
for start-up
torque 71 time period at begin of run, in which the
“maximum start-up torque” applies (value
in msec, see also Par. 63) 10...1000
16 bit yes 200 R/W
*) Values depend on device type (see following table).