Assembly instruction
– PSD4xx positioning system
© 10.06.2020, halstrup-walcher
- 3 -
7100.006394_Assembly instruction_PSD4xx
WARNING
Risk of burns due to hot drive.
The drive can become very hot during operation.
Allow the drive to cool before touching it.
WARNING
Risk of crushing due to rotary movement.
Do not reach into the working area of the drive when it is
still turning.
The user/operator must ensure appropriate protective
measures are taken.
WARNING
Incorrect installation can lead to the destruction of the
drive.
WARNING
Check that the supply lines are not pinched or crushed.
Lay the supply lines according to the general and specific
local installation regulations.
If the supply lines have not been delivered together with the
device, please select suitable cables for the application.
Do not operate the positioning unit if the supply lines are
noticeably damaged.
WARNING
Risk of injury.
High contact voltages can occur in the case
of malfunctions.
This can be prevented by grounding.
WARNING
The drive must only be installed and wired when it is
disconnected from the power supply.
Storage and transportation of devices
The PSD4xx positioning drive should always be stored and
transported to the place of installation in its original packaging.
Maintenance, cleaning and repair of
devices
The drive requires no maintenance. The drive may only be
cleaned from the outside with a damp cloth.
Repairs should only be carried out by the manufacturer.
Installing the device
Depending on the model, the device can be installed on the
machine using a hollow or solid circular shaft.
ATTENTION
Never apply force to the housing of
the drive, e.g. for supporting weight.
Installing a drive with hollow shaft
How to mount the drive on a shaft
Tools required: 3 mm Allen key.
Example:
Instructions:
1.
Slide the drive onto the shaft to be driven.
2.
Guide the torque support into the hole provided by the
planner.
3.
Slide the drive towards the machine base until the sealing
plate is pressed together to approx. the half thickness.
4.
Now tighten the adjustable collar screw with 4 Nm.
The drive is now installed.
Note:
Ensure that the drive and machine base are as
parallel to each other as possible.
INCORRECT
CORRECT
ATTENTION
Under no circumstances must the
drive be bolted on “hard” without an
air gap between it and the machine.
The sealing plate is used for
tolerance compensation.
