98217C (1/06)
HVR8FR*1A
Page 3
IMPORTANT
ALL SERVICE TO BE PERFORMED BY
AN AUTHORIZED SERVICE PERSON
HANGER BRACKETS & TRAP
INSTALLATION
1) Remove hanger bracket fastened to back of cooler by removing one (1) screw.
2) Mount the hanger bracket and trap as shown in Figure 2.
NOTE: Hanger Bracket MUST be supported securely. Add fixture support carrier
if wall will not provide adequate support.
IMPORTANT:
y
6 1/4 in. (159mm) dimension from wall to centerline of trap must be main-
tained for proper fit.
y
Anchor hanger securely to wall using all five (5) 1/4 in. dia. mounting holes.
3) Install straight valve for 3/8" O.D. tube.
INSTALLATION OF COOLER
4) Hang the cooler on the hanger bracket. Be certain the hanger bracket is engaged
properly in the slots on the cooler back as shown in Figure 2.
5) Loosen the two (2) screws holding the lower front panel at the bottom of cooler
base and two (2) screws at the top (Use torx bits sold separately). Remove the
front panel and set aside.
6) Connect water inlet line--See Note 4 of General Instructions.
7) Remove the slip nut and gasket from the trap and install them on the cooler
waste line making sure that the end of the waste line fits into the trap. As-
semble the slip nut and gasket to the trap and tighten securely. Recommend
fastening cooler to wall using 7/16 bolt holes. (see fig.2, "F")
START UP
Also See General Instructions
8) Stream height is factory set at 45-50 PSI. If supply pressure varies greatly
from this, adjust screw using the access hole in the pushbutton (insert screw-
driver). CW adjustment will raise stream and CCW adjustment will lower
stream. For best adjustment, stream should hit basin approximately 6-1/2”
(165mm) from bubbler.
Stainless Steel
PANEL COLOR
COLOR TABLE
Item No. 37
Part No.
Item No. 32
Part No.
Item No. 33
Part No.
Item No. 34
Part No.
Item No. 35
Part No.
Item No. 36
Part No.
28525C
28519C
28516C
28528C
28522C
22955C
Fig. 3
VANDAL RESISTANT BUBBLER DETAIL
15
1
4
Basin
