Halsey Taylor HVRBLFR Series, Руководство пользователя

Страница: 4 / 6

Page 4 98353C (Rev. J - 01/19)
HVR8BLFR*1B HVRDBLFR*C
Stainless Steel
PANEL COLOR
COLOR TABLE
Item No. 37
Part No.
Item No. 32
Part No.
Item No. 33
Part No.
Item No. 34
Part No.
Item No. 35
Part No.
Item No. 36
Part No.
28525C 28519C 28516C 28536C 28522C 22955C
Refrig. Unit
Stainless Steel
PANEL COLOR
COLOR TABLE
Item No. 37
Part No.
Item No. 32
Part No.
Item No. 33
Part No.
Item No. 34
Part No.
Item No. 35
Part No.
Item No. 36
Part No.
28539C 28519C 28516C 28528C 28522C 22955C
Left Unit
IMPORTANT
ALL SERVICE TO BE PERFORMED BY AN
AUTHORIZED SERVICE PERSON
HANGER BRACKETS & TRAP
INSTALLATION
1) Remove hanger bracket fastened to back of cooler by removing one (1) screw.
2) Mount the hanger bracket and trap as shown in Figure 2.
NOTE: Hanger Bracket MUST be supported securely. Add fixture support carrier if wall
will not provide adequate support.
IMPORTANT:
• 6-1/4 in. (159mm) dimension from wall to centerline of trap must be maintained for
• proper fit.
• Anchor hanger securely to wall using all five (5) 1/4 in. dia. mounting holes.
3) Install straight valve for 3/8” O.D. tube.
INSTALLATION OF COOLER
4) Hang the cooler on the hanger bracket. Be certain the hanger bracket is engaged properly
in the slots on the cooler back as shown in Figure 2.
5) Loosen the two (2) screws holding the lower front panel at the bottom of cooler base
and two (2) screws at the top (Use torx bits sold separately) . Remove the front panel
and set aside.
6) Connect water inlet line--See Note 4 of General Instructions.
7) Remove the slip nut and gasket from the trap and install them on the cooler waste line
making sure that the end of the waste line fits into the trap. Assemble the slip nut and
gasket to the trap and tighten securely.
START UP
Also See General Instructions
8) Stream height is factory set at 45-50 PSI. If supply pressure varies greatly from this,
adjust screw using the access hole in the pushbutton (insert screwdriver). CW adjust-
ment will raise stream and CCW adjustment will lower stream. For best adjustment,
stream should hit basin approximately 6-1/2” (165mm) from bubbler.
Basin
Fig. 3
VANDAL RESISTANT BUBBLER DETAIL
1