HT - EBP*E HT - SBP*E HT - SEBP*K HT - ESBP*K
97086C (Rev. B - 4/98)
Page 2
HT - EBP/SBP/SEBP/ESBP COOLER INSTALLATION
1. Wall should already be framed for the fountain using the rough-in dimensions shown
in Fig’s. 3,4,5, or 6. Shown dimensions pertain to installation location (framing must support
up to 150 lbs. weight for single fountain and 300 lbs. for dual fountains). These dimensions
are required for compliance with ANSI Standard A117.0.
2. Attach hanger bracket to wall as shown in Fig’s. 3,4,5, or 6 using 5/16" x 3/4" long bolts and
flat washers (not provided). Tighten securely.
3. Install back panel. Place the upper edge of the panel above hanger on the wall. Slide the
panel down until it engages the hanger. Be sure back panel is firmly engaged before
releasing it.
4. Install rough-in plumbing as shown in Fig’s. 3,4,5, or 6. Waste line should extend a
minimum of 2" (51mm) thru the back panel. Run supply water inlet line thru back panel.
Install a service stop (not provided). Turn on supply water and flush thoroughly.
5. Remove bottom access panel from fountain basin and save the screws. Install the fountain
to the back panel and wall using (4) 5/16 “ x 2” long lag bolts and washers (not provided)
thru holes in back panel. Tighten securely.
6. Cut waste tube to required length using plumbing hardware and trap (not provided) as a
guide. Install hardware and trap. Tighten securely.
7. Make water supply connections from service stop to the fountain strainer. Insert the
water inlet line into the inlet side of strainer until it reaches a positive stop - about 3/4"
(See Fig. 2). Turn on water supply and check for leaks. Newly installed water supply line
should be insulated after leak check is completed. DO NOT SOLDER TUBES INSERTED
INTO THE STRAINER AS DAMAGE TO THE O-RINGS MAY RESULT.
8. Check stream height from bubbler. Stream height is factory set at 45-50 PSI. If supply
pressure varies greatly from this, adjust the screw on regulator (item 13, on page 7).
Clockwise adjustment will raise stream height and counter-clockwise will lower stream
height. For best adjustment stream height should be approximately 1-1/2" (38mm) above
the bubbler guard. (See Figure 8)
9. Water Valve Mechanism - ADJUSTMENT PROCEDURE:
- Turn adjustment screw (Item 7, page 7) counter-clockwise until water flow from
bubbler starts
- Turn adjustment screw clockwise until water flow stops, then turn an additional
1/2 turn
10. Replace bottom access panel to fountain using the screws provided. Tighten securely.
