LED Wall Pack Instructions
www.cooperlighting.com
IL51879322
3
ENGLISH
1. TURN OFF THE ELECTRICITY
•
Verify the wall switch is in the OFF position.
•
Turn off power at the circuit breaker that supplies power to the outlet box you are working on.
•
For screw-in type fuses unscrew the fuse that supplies power to the outlet box you are working on.
INSTALLATION
OFF
ON
OFF
ON
OFF
ON
OFF
ON
WARNING:
Risk of electric shock. Disconnect power
at fuse or circuit breaker before installing or servicing.
2
.
REMOVING THE MOUNTING BASE
•
Loosen the two mounting base screws (C) using a Phillips screwdriver to open the fixture.(Fig.1)
•
The fixture opens sideways from the mounting base (D) and stays connected on the hinge. (Fig. 2)
CAUTION
:
DO NOT touch the LED and photocell lens (E)
inside the fixture.DO NOT damager or soil the reflector.
NOTE
:
The mounting base screws (C) come pre-installed
on the light fixture.
Fig. 1
Fig. 2
3
.
REMOVING THE KNOCK OUTS ON THE MOUNTING BASE
•
For junction box mount: Measure the size of your junction box and refer to the guide in the figure
to select the holes to knock out.
NOTE
:
If necessary, you may drill out mounting holes through the back plate
housing to correspond with the junction box or wall surface for level mounting.
•
For surface mount: Measure the distance between two holes, pre-drill holes into the mounting
surface, and drill holes on the desired ring accordingly.
•
Use a power drill with a 1/4" drill bit to drill out the holes.
4
.
•
Remove the entry plug in the mounting base and
Route the junction box wires through the large
center hole in the mounting base (D).
•
Align the holes on the mounting base (D) with the holes on your junction box. Use two (2) or four
(4) screws,depending on the size of the holes in your junction box, to attach the mounting base
(D) to your junction box. (Fig. 1)
INSTALLING THE MOUNTING BASE
AND CAULK
Junction Box
•
Mark and drill two to four holes on the wall surface as per the desired location for installing the
mounting base (D).
•
Use two or more suitable screws (not included) applicable to the surface of mounting and
attach the mounting base (D) on the surface. (Fig. 2)
Surface Conduit Mount
Fig. 1
Fig. 2
•
Align the holes in the fixture mounting base (D)and the EVA foam (CC)then attach the EVA foam
to the mounting base.
•
Caulk around the EVA Foam (CC) and surface with silicone
sealant (not included).
•
F
or 3-1/4 in. junction box: Knock out two holes in the inner ring.
•
F
or 4 in. junction box: Knock out two holes on the outer ring.
C
D
D
NOT
ICE
:
Failure to properly caulk around the surface and mounting base (D) could lead to
water damage and is not covered under warranty.
NOTE
:
When attaching this fixture (A) to an external surface mount junction box,caulk
the inside of the light fixture before attaching to the mounting base (D).
