HALO Ultra Plus Reverse Osmosis System
6
IMPORTANT!!
PLEASE READ THE FOLLOW AND SAVE THIS INSTRUCTION MANUAL.
1. PRE-INSTALLATION PROCEDURE
1.
This unit includes a standard sink top faucet without
an air-gap. In localities where plumbing codes require
installation of an air-gap, contact your local distributor to
obtain a code approved drain line adaptor.
2.
The reverse osmosis system may be mounted to the side of
the sink cabinet or set on the floor of the sink cabinet. It must
be positioned to allow access for service and filter changes.
The assembly should be relatively near the faucet to maximize
flow rate. (
See DIAGRAM A for a positioning example.)
3.
The storage tank should be located where it can be removed if
necessary. The storage tank may be placed in either the vertical
or horizontal position without affecting the system performance. If there is insufficient space
under the sink for placement, the tank may be located in an adjacent cupboard up to 50 ft. away.
(
See DIAGRAM A for a positioning example.)
4.
The faucet should be positioned to allow a free flow pattern into the sink. It must be
positioned to allow ready access to the mounting hardware under the sink.
(
See DIAGRAM A for a positioning example.)
2. SMART FAUCET INSTALLATION
CAUTION!!
Extreme care must be taken in drilling the hole for the sink-top faucet. The surface
material of most sinks is extremely hard and brittle and can be easily chipped or cracked.
If you are uncomfortable performing the following procedure it is recommended that your
experienced contractor be consulted for techniques, installation or other assistance. The system’s
manufacturer accepts no responsibility for sink top damage resulting from system installation.
EXTREME CAUTION SHOULD BE TAKEN WITH GRANITE, MARBLE AND LIKE MATERIAL.
CAUTION!!
Before grinding or drilling put on appropriate eye protection (i.e. goggles)
to protect yourself from porcelain or metal chips.
CAUTION!!
To avoid damaging the sink, consult a qualified contractor for drilling procedures.
Special drill bits may be needed for porcelain or stainless steel.
WARNING:
Many homes are electrically grounded through the plumbing. To protect yourself
from serious injury or fatal shock, use a battery-powered hand drill only to make the hole. DO NOT
USE A CORDED ELECTRIC DRILL.
1. BEFORE DRILLING:
Check under the sink in the area that you plan to install the faucet
and make sure that there is a flat surface to secure the mounting hardware. A flat space of
approximately 2 inches in diameter is needed.
RECOMMENDATION: Before drilling or grinding mask off the immediate area surrounding the grinding/drilling
location preferably with duct tape or if duct tape is unavailable masking tape may be used. This procedure should
help prevent scratching of the sink surface.
Pre & Smar t Faucet Installation
DIAGRAM A
