75.5172.03 20060608
2/2
2
Function:
To assemble or disassemble the pushplate, use the enclosed hex key (or
similar diameter tool) to press in and release the spring clips from the
faceplate bracket. The spring clip will need to be engaged/ disengaged
from top and bottom, one at a time. When the spring clips are correctly
engaged, they will make a
click
. It may be necessary to rotate the
faceplate slightly to have them lock correctly.
To replace the battery, remove the faceplate and the four (4) screws
holding the battery cover to expose the transmitter assembly. Replace
the battery with a fresh 12V, Type A23 battery and reassemble the
pushplate.
WARNING:
DO NOT OVER TIGHTEN THE SCREWS ON THE
BATTERY COVER. THIS MAY CAUSE THE TRANSMITTER TO BE IN
CONSTANT ACTIVATION. THE HEAD OF THE SCREWS SHOULD
BE FLUSH WITH THE TOP OF THE PLASTIC COVER.
3
Tips
•
Shut off all power going to the header before attempting any wiring procedures.
•
Maintain a clean & safe environment when working in public areas.
•
Constantly be aware of pedestrian traffic around the door area.
•
Always stop pedestrian traffic through the doorway when performing tests that may result in unexpected reactions by the door.
•
Always check placement of all wiring before powering up to insure that moving door parts will not catch any wires and cause damage
to equipment.
•
Ensure compliance with all applicable safety standards (i.e. ANSI A156.10) upon completion of installation.
4
Receiver Setup:
To program the receiver (pn 10RD433 sold separately), perform the following steps:
1.
On the 433MHz digital receiver, press the brown learn button once (the yellow LED will illuminate).
2.
Within 20 seconds, press the faceplate of the assembled pushplate once (the yellow LED on the receiver will go out).
3.
Press the faceplate again (the yellow LED will flash for 2 seconds).
4.
Press the faceplate again to verify receiver detection (the yellow LED will flash and the red LED will illuminate for the length of time set by
the dipswitch).
NOTE: To clear the memory of the receiver, press and hold the learn button for 10 seconds.
For additional information about the receiver, please review the manual for the 10RD433 receiver.
4 Company Contact
BATTERY LOCATION
(OBSERVE PROPER POLARITY)
PRESS
(TOP AND THEN
BOTTOM)
DETACH/
REATTACH
(LISTEN FOR
CLICK)
Do not leave problems unresolved. If a satisfactory solution cannot be achieved after troubleshooting a problem, please call B.E.A.,
Inc. If you must wait for the following workday to call B.E.A., leave the door inoperable until satisfactory repairs can be made. Never
sacrifice the safe operation of the automatic door or gate for an incomplete solution.
The following numbers can be called 24 hours a day, 7 days a week. For more information, visit
www.beainc.com
.
West: 1-888-419-2564
Mid-West: 1-888-308-8843
South-East: 1-800-407-4545
North-East: 1-866-836-1863
US and Canada: 1-866-249-7937
Canada: 1-866-836-1863
