GB-8
INSTALLING HANDLE (BCG1E34F)
•
Mount the handle to the shaft tube and clamp it at a
location that is comfortable to you.
INSTALLING HANDLE (BCG1E40F-5)
1.
Loosen the 4bolts on the upper cap and insert the
handles equally. Retighten the bolts.
2.
Put the handle assembly into the bracket and put the
upper cap over it. Tighten the cap securely.
INSTALLING DEBRIS GUARD FOR LINE HEAD
•
Attach the debris guard with the bolts provided while
inserting the spacer between the guard and the pipe.
6. Set up
INSTALLING DEBRIS GUARD FOR METAL BLADE
•
When using metal blade, make sure to remove the
guard skirt.
BALANCE UNIT
1.
Put on strap and attach unit to strap.
2.
Slide clamp up or down until unit balances with head
aparting from the ground when using it.
- Position the blade (
C/4
), thrust washer (
C/5
) and finally the
floating disc (
C/6
) as shown.
- Screw down the locknut (
C/7
) and tighten it by turning the
combination wrench counter-clockwise.
Caution:
For safety reasons, after every 10 tool changes
the locknut (
C/7
) must be replaced with a new one.
- Remove Allen key and check for freedom of motion of the
cutting tool.
C
MoUnTIng THE 3 or 4 TEETH BLaDE
always switch off the engine and disconnect the spark plug
cap before mounting metal cutter blades!
- Unscrew the locknut (
C/7
) from the shaft by turning it clock-
wise. If necessary, block the angle gear (see below).
note:
Remove the cotter pin.
-
The locknut is provided with a left-hand thread!
Remove floating disc (
C/6
) and thrust washer (
C/5
).
- Insert the offset screwdriver 4 mm (
C/1
) through the wind-
ing guard and the locking disc into the opening (
C/3
) in the
angular gear (block the winding gear). If necessary turn the
mounting disc (
C/3
) slightly.
-
InSTaLLIng THE TrIMMEr HEaD
Always switch off the engine and
nect the spark plug cap
mounting the trimmer head!
D
- Place the mounting disc (
D/3
) on the shaft.
- Insert the 4 mm Allen key (
D/1
) through the winding guard
and the mounting disc (
D/3
) into the opening on the angle
gear (blocks the angle gear). If necessary turn the mounting
disc (
D/3
) slightly.
- Screw the trimmer head (
D/2
) onto the shaft by turning it
counter-clockwise.
- Now tighten the trimmer head by hand.
- Remove the Allen key and check for freedom of motion of
the trimmer head.
- Put back the cotter pin.