Hall Technologies December 29, 2022
Page 14 of 18
Setup
INSTALLATION
Note:
Before installation, please ensure the devices are disconnected from the power source.
To install the device on
a surface
:
1.
Secure the included L-bracket mounts to each side of the transmitter/receiver using the
included screws.
2.
The bottom part of the L-bracket should be flush with the bottom of the transmitter/receiver.
3.
Using the appropriate hardware (not included), mount the bottom of the L-brackets to the
desired surface.
FIRMWARE UPDATES
1.
Locate Tera Term software in the firmware folder, or download it at:
https://osdn.net/projects/ttssh2/releases/
2.
Connect the EX-LYNX device to the laptop using a Micro USB cable.
3.
Run the Tera Term software
4.
Select the correct Serial Port (typically CH340) and then click
Ok
.
5.
Set the serial port connection to have a baud rate of 115200.
6.
Go to File, Transfer, YMODEM, and then connect Send.
7.
Select the firmware file “xxxxx.bin” then click
Open
.
8.
The upgrade progress bar will show the status of the upgrade.
9.
A pop-
up window saying “Programming Completed Successfully” when complete.
