4 or 8 Channel Splitter PC Video & Audio over Twisted-Pair Receivers
7
3.3 Advanced Brightness Adjustment on URA Receivers
The URA series of devices can equalize the brightness of the video by reducing
smearing.
•
Apply power to the receiver. Wait until all LED’s are turned off
•
Press the SEL button once to enter
Adjustment-mode
.
•
In
Adjustment-mode
, all three (3) LEDs will be ON solid.
•
Press and hold the SEL button for at least 3 seconds to enable the
Video Brightness Adjustment Mode
(previously called Wire Gauge
Mode).
•
In
Video Brightness Adjustment Mode
, the GREEN and BLUE
LED’s will be blinking.
•
The UP button raises the video brightness level.
•
The DOWN button lowers the video brightness level.
•
Pressing BOTH the UP and DOWN buttons at the same time will
reset the Video Brightness to the default setting.
•
While using the UP and DOWN buttons, if an upper or lower limit of
the adjustment is reached, the brightness will no longer change with
each button press.
•
To exit the
Video Brightness Adjustment mode
at any time, press
the SEL button until all LED’s are ON solid (
Adjustment-mode
).
Press the SEL button repeatedly until all LED’s are OFF indicating the
unit is ready for operation. (The unit will automatically return to this
mode after 1 minute if no buttons are pressed).
Note
The Video Brightness adjustment may not be noticeable when only using 1 device.
When products are daisy-chained using the –XT version the adjustment is easier to
observe.
