Model URA, URA-SKU, & URA-XT
12
Adjust
First
Adjust
Second
3.6 Signal Adjustment for the Daisy Chain
There are no specific procedures for adjusting the URA-XT’s other
than the order the adjustment is made.
The URA-XT’s RJ45 (Cat5) output is the video signal AFTER IT HAS
BEEN ADJUSTED.
This means that the unit closest to the sender has to be adjusted first.
Set the high frequency compensation first and then adjust the skew.
Since the effects in the daisy chain are cumulative, we recommend
that you set the gauge of CATx cable used as well (see section 3.3
above).
Remember, if the calibration is off on a URA-XT in the middle of a
daisy chain and you adjust the device settings you must then check
the rest of the downstream devices and if necessary; make additional
adjustments on those devices as well.
Figure 8 – Daisy-Chain adjustment sequence
