9
Fig 12
WARNING
Remove the foam from the wheel axles and discard immediately. Do not remove the washers.
1. Lift the trailer back so the right side is up, and locate the right wheel marked with an “R” sticker.
2. Position the wheel with the stub axle next to the hole in the left wheel bracket (Fig9)
3. Slide the stub axle completely through the hole in the bracket so the wheel is in the use position (Fig10).
4. Tip trailer frame to allow access to the underside of trailer. Locate hole in end of hub axle.
5. Slide the quick-release pin (tethered to the bike frame near the wheel bracket) through the hole in the stub .
axle and loop the end over the shaft of the pin (Fig11, Fig 12 ). Repeat for the left wheel
NOTE
: Wheels must be properly installed with quick release pins close and snapped shut. If QR pins are not
correctly attached, wheels may fall off. Do not use if QR pins are missing, or if the closure is damaged or
missing.
