HALE SmartFOAM 1.7AHP, Описание, установка и руководство по эксплуатации, Страница: 64 / 93

Page 63
SmartFOAM
SYSTEM INSTALLER START-UP
On initial power-up of the Hale SmartFOAM system at
the installer facility, the following procedures must be
followed.
INITIAL SYSTEM POWER CHECK
Watch the display on the controller unit as the apparatus
electrical system is turned ON. Check the controller unit
readout for:
❑
SmartFOAM booting screen is shown for three
seconds.
❑ SmartFOAM splash screen is shown for three
seconds.
❑
SmartFOAM version screen is shown for two
seconds.
❑ SmartFOAM preset screen is shown (default)
OR
SmartFOAM classic FoamLogix screen is
shown.
(The screen shown
depends on the “display
format” chosen in the user menu).
(See Figure 44
: Controller Unit Initialization ).
If a default display does not appear, refer to the
TROUBLESHOOTING section for possible WARM-UP/
SYSTEM CHECKING causes and solutions.
INITIAL SYSTEM CHECK
After initial system power-up the low tank level sensor
operation, foam pump operation, and flow sensor
calibration must be checked per the following:
CAUTION!
WATER IS USED AT THE SYSTEM INSTALLER
FACILITY TO VERIFY LOW TANK LEVEL SENSOR
SYSTEM READY OPERATION AND FOAM PUMP
OPERATION AS THE END USER SPECIFIED FOAM
CONCENTRATES MAY NOT BE READILY
AVAILABLE.
DO NOT PUMP WATER WITH THE HALE FOAM-
LOGIX FOAM PUMP FOR MORE THAN ONE (1)
MINUTE. DO NOT ATTEMPT TO CALIBRATE FOAM
PUMP FEEDBACK SENSOR WITH OTHER THAN
END USER SPECIFIED FOAM CONCENTRATE.
MAKE SURE THE BYPASS VALVE IS IN THE
BYPASS POSITION WHEN PUMPING WATER WITH
THE FOAM PUMP.
Figure 44 : Controller Unit Initialization