HALE SmartFOAM 1.7AHP, Быстрый старт по калибровке пены

Страница: 6 / 10

Page 5
SmartFOAM
❑
The cord sets provided with each Hale Foam system are indexed to ensure correct receptacle installation (they insert
one way only). When making cord set connections DO NOT force mismatched connections as damage can result in
improper system operation.
❑
Make sure all connections are sound, and that each connection is correct.
❑
The cables shipped with each Hale Foam system are 100% tested at the factory with that unit. Improper handling and
forcing connections can damage these cables which could result in other system damage.
❑
There are no user serviceable parts inside Hale Foam system electrical/electronic components. Opening of the motor
controller or controller unit voids the warranty.
❑
Use mounting hardware that is compatible with all foam concentrates to be used in the system. Use washers, lock
washers and cap screws made of brass or 300 series stainless steel.
❑
When making wire splice connections, make sure they are properly insulated and sealed using an adhesive filled heat
shrink tubing.
❑
ALWAYS connect the primary positive power lead from the terminal block to the master switch terminal or the positive
battery terminal.
❑ Use a minimum 8 AWG type SGX (SAE J1127) chemical resistant battery cable and protect with wire loom.
❑
Prevent corrosion of power and ground connections by sealing these connections with silicone sealant provided.
❑ Prevent possible short circuit by using the rubber boot provided to insulate the primary power connection at the Hale
SmartFOAM motor controller.