HDV R 14 1.1
Due to constant technological advancement, the manufacturer may modify the content of this manual without prior notice.
7
After removing the shell, stand the HDV vertically, detach the red connector (15) (do not
pull the wires), unscrew the ring nut (11), remove the terminal (12) (see fig. 2) and extract
the battery (14) pulling it upwards off the rod (13). (see fig. 3)
4.3
Recharging the battery
Figure 4
To recharge the battery, put it in a safe place away from people and flammable objects.
connect the charge connector (24) to the battery charger (see battery charger
instructions). Next connect the battery charger power cord to the mains. When charged,
disconnect the battery charge.
WARNING: do not use the battery charger with the power cord damaged or broken.
Electrical shock hazard with even fatal consequences.
4.4
Inserting the battery
With the HDV in vertical position, repeat the battery extraction procedure in reverse order,
being careful to insert the rear stops (16) between the battery support rods (see fig. 3).
After inserting the battery, connect the terminal (12) and tighten without forcing the ring nut
(11) (see fig. 5) being careful to only connect the red connector (15) if the HDV is
immediately used.
Figure 5