3.
Audio Setup
To setup the audio system it is necessary to tell the SSP100 what speaker configuration
you are using, e.g. 5.1, 6.1, 7.1. The SSP100 also needs to know if the speakers are Large
(full bandwidth) or Small. This activates the bass management options and range of audio
processing modes available for use. The audio amplifier needs to be connected to the
7.1 balanced or unbalanced outputs.
·
Connect the amplifier to the SSP100 audio outputs (rear panel 19 or 44)
·
Connect the SSP trigger 1 to the MC amplifier trigger input (rear panel 33)
·
Speaker setup
·
In the Speaker setup menu select Size setup and enter the speaker size for
each group. If some speaker channels are not to be active enter No .
·
If the Main speakers are Small a subwoofer must be used
·
To save the settings press the MENU key or Exit from each page.
·
Switch off the menu.
·
Using the remote control set the SSP100 mode to Direct using the MODE +/-
keys on the remote control. For 7.1 speaker systems select THX
Ultra2 Cinema or PLIIx.
·
Check the required output connections and A/V formats are enabled in the DVD s
own setup menu
·
Switch on a DVD and audio and video will be present
MAIN MENU
>
Speaker setup
Audio setup
Source setup
Display setup
THX Audio setup
Trigger setup
EXIT
SPEAKER SETUP
Level setup
Distance setup
>
Size setup
Aux channel setup
Level Autocalibrate?
Dist. Autocalibrate?
EXIT
SIZE SETUP
>
Main speakers
Large
Center speaker
Small
Surround speakers Small
Back speakers
2Small
Subwoofer
Yes
Subwoofer filter
On
Subwoofer freq.
80 Hz-THX
Enhanced bass
Off
EXIT
