Page 14
TM
dm38
Care and Maintenance
The HALCRO™ dm38 has been designed for indoor use only. Under no circumstances
should the amplifier be allowed to get wet. The only maintenance required will be
ensuring the unit is kept clean.
Important
HALCRO™ takes no responsibility for any damage caused through careless or
improper cleaning techniques. Never use flammable products when cleaning the
HALCRO™ dm38.
Please read the following procedures very carefully
•
The outer surface of the unit is anodized aluminum, which while being very
durable, will be marked if rubbed with an abrasive cloth.
•
Prior to cleaning, turn the power to the unit off at the mains.
•
Use only extremely soft cloths.
•
Use a soft dry cloth to remove any dust, particularly from the heatsink area.
•
Add 15 mls (0.5 oz) of very mild household dishwashing detergent to a 4-litre (1
gal) bucket of luke warm water.
•
Immerse the soft cloth in the bucket of water, then wring the cloth out thoroughly
until the cloth is nearly dry.
•
The slightly damp cloth should only ever be used to clean the anodized aluminum
surfaces and timber feet. Never clean any electrical fittings, terminals or the front
and rear Labels with the damp cloth. The labels can be cleaned using an extremely
soft polishing cloth, which must be dry. No moisture should ever be allowed to
enter the amplifier's compartments through the joins in the panels.
•
After using the slightly damp cloth, wipe over the surfaces with a soft dry cloth,
and then allow the amplifier to air for at least one hour prior to turning the power
back on.
•
If you are unsure about the cleaning of the amplifier and require more information,
please ask your dealer or contact HALCRO™ at
