Hakko Electronics Monitouch V Series, Справочное руководство

Страница: 82 / 746

Chapter 2 Overlap
2-17
2
C
a
ll-o
ve
rl
a
p
[Item Select]
This is required when using entry mode on the overlap.
For more information, refer to “Chapter 7 Entry Mode.”
[MLIB Placement]
Determine the overlap display position.
The relationship between the
placement and the overlap is that the
left corner of the mark becomes the left
corner of the multi-overlap as shown in
the diagram to the right.
Displaying and Erasing Call-overlap
To display or erase the call-overlap on the screen, the following three commands
can be used.
♦
Internal command
The overlap is displayed or erased by pressing the switch placed on the screen.
The following switches can be used.
♦
External command
The call-overlap is displayed or erased by activation of a bit in the PLC memory.
The displaying and erasing method is the same as that for normal overlap.
Refer to page 2-6.
♦
Macro command
Using a macro command, the call-overlap can be displayed, erased or moved.
Use the OVLP_SHOW and OVLP_POS commands.
For more information, refer to “Chapter 13 Macro.”
Memory Related to Call-overlap
•
Item selection memory ([Overlap (Normal)] dialog)
This is valid when the entry mode is used on the overlap and [
Item Select]
is checked.
•
Read area (n + 1)
Use this memory when displaying and erasing the call-overlap according to
the command from the PLC. The overlap is displayed or erased when the
leading or falling edge is detected.
MLIB
Multi-Overlap
Mark
Operation Switch Function Attached Setting
Displaying a call-overlap Overlap ON
Erasing the call-overlap Overlap OFF
For more information on the overlap switch, refer to “Chapter 3 Switch.”