Hakko Electronics Monitouch V Series, Справочное руководство

Страница: 198 / 746

Chapter 7 Entry Mode
7-7
7
[T
y
pe: Dir
e
c
t]
[Type: Direct]
The entry format, the number of digits, the decimal point position, etc. are
externally commanded via the memory address. Numerical data is written to the
information output memory addresses “n + 2” and “n + 3.” Characters are
written to the information output memory addresses starting from “n + 2.”
♦
Setting Items
•
[Part]
→
[Entry]
Data Reading Steps
Data is read using the following steps.
A: [Command memory] B: [Information output memory]
* Once bit 15 of the address “n” (information output memory) is set (ON), it is not reset automatically.
Be sure to set.
Set if necessary.
Entry Dialog See page 7-8.
New:
Existing:
Entry Display See page 7-29.
Keypad See page 7-20.
A The entry format, the number of digits, the decimal point position, etc. are specified via
the addresses of “n” (command memory) and “n + 1.”
B The entry display part for the specified entry format, the number of digits, and the decimal
point position, etc. becomes active.
B Check that bit 14 (input) of “n” (information output memory) is set (ON).
Enter the desired data through the keypad and press the ENT key.
B Check that bit 15 (writing completed) of “n” (information output memory) is set (ON).
Also, check that the data is written to “n (information output memory) + 2” and “n + 3.”
B The data in “n (information output memory) + 2” and “n + 3” is read.
B
Reset (OFF) bit 15 (writing completed) of the address “n” (information output memory).
*
A Set (ON) bit 15 (clear) of the address “n” (command memory).
Check that the entry display part indicates “0.”
A Reset (OFF) bit 15 (clear) of the address “n” (command memory).
Check that the entry display part becomes active again.