Hakko Electronics Monitouch V Series, Справочное руководство

Страница: 220 / 746

Chapter 7 Entry Mode
7-29
7
En
tr
y D
is
p
la
y
Entry Display
When setting data display part, [Entry Display] must be chosen for [Display
Function]. The data entered through keypad is displayed temporarily. When the
ENT key is pressed, it is written to the entry target memory. If this part has not
been set, data entered through keys is indicated directly in an entry target.
Notes on setting of entry displays are provided below. For the other setting
items, refer to “Chapter 5 Data Display.”
♦
[Main] Tab Window
[Division No.]
Be sure to specify the same division number as in the [Entry] dialog.
(Division number:
Refer to Chapter 2 in the Reference Manual
(Operation).)
♦
[Type] Tab Window
[Display Function]
Be sure to select [Entry Display].
[Digits]
The number of digits set for entry display must be greater than that of the
entry target. If not, the data for the entry target exceeding the maximum
number of digits for the entry display cannot be held in the entry display part.
[Decimal Point]
When the entry targets have the same settings of [Digits] and [Decimal
Point], enter the same value of [Decimal Point] for the entry display.
In the case that the settings of [Digits] and [Decimal Point] differ for each
entry target:
When there are entry targets for which [Decimal Point] is set, specify “1” for
the entry display. When there is no entry target for which [Decimal Point] is
set, specify “0” for the entry display.
[Display Type]
When the entry targets have the same setting of [Display Type], specify the
same for the entry display. When the setting of [Display Type] differs for
each entry target, choose the setting for the greatest number of digits.