OPERATION
●
Attach the iron holder.
Remove the iron holder mounting screws
from the side of the station.
Attach the iron holder to the station.
(Figure 1)
(The iron holder can be installed on the either
the left or right side.)
●
Attach the desoldering iron.
1. Insert the filter pipe (with a filter holder,
spring filter and ceramic paper filter (L))
into the housing.
Push and turn the back holder clockwise.
(Figure 2)
2. Connect the cord assembly of the Hakko
807 to the receptacle. (Figure 3)
3. Connect the hose to the vacuum outlet
cap. (Figure 4)
4. Set the iron in the iron holder. (Figure 5)
5. Plug the power cord into the power supply
and turn the power switch to ON ( ).
CAUTION:
Be sure the power switch is OFF (
) before
connecting the desoldering iron cord. Failure to do
so may result in damage to circuit board.
●
Desoldering
1. Set the temperature.
(Refer to P.6)
NOTE:
Always set the temperature as low as possible for the
work being done.
The temperature can be adjusted between 350 –
450
°
C (662 – 842
°
F).
Secure the plug by
turning it clockwise.
Attach the hose securely
over the vacuum outlet
cap.
Insert the cord
assembly by keying
the plug to the key
on the receptacle.
VACUUM
(Figure 1)
(Figure 5 ) Top view
(Figure 2 )
(Figure 3)
(Figure 4)
CAUTION
When not in use, place the iron
on the iron holder.
4