MB21 (21 Slot) Chassis
MB21 Installation
MB6 and MB21 Multichannel Chassis Installation Guide, v2.0, Issue 01
19
A
= handle screw hole
B
= mounting screw hole
C
= chassis mounting flange
D
= slot cover
E
= support bracket screws (optional)
F
= support bracket screws (optional)
G
= support bracket flange
Figure 13: MB21 Chassis Installation
8.
Loosely fasten the support brackets to the sides of the chassis with hex nut screws at (
E
) and (
F
). Slide them
into place and secure them to the back of the rack (see
red
arrows in figure above; screws
not
provided).
NOTE
If you need to further extend the support brackets, you may safely remove the two screws at po-
sition (
E
) on each side.
9.
Using a 5/16 hex nut driver, tighten the four screws at position (
F
) on each support bracket.
10.
If needed, tighten the two screws at position (
E
) on each support bracket.
11.
Using a Phillips #1 screwdriver, remove slot covers (
D
) as required.
CAUTION
Failure to properly secure or support the MB21 as described above may result in serious
damage to the enclosure and/or its contents.
12.
(F-MB21X-R only) If using a system interface, insert it now. The mating connector is provided but you will
need to add your own wiring.
13.
Insert the cards from the front (as shown in
Alignment of chassis mounting
flange holes with rack
Alignment
notch
A
B
4U
½"
⅝"
E
F
G
C
D
Содержание MB21
Страница 1: ...MB6 and MB21 Multichannel Chassis Installation Guide v2 0 HVS ID IG MB6 MB21 20 Issue 01 ...
Страница 29: ......
