Haivision Makito, Руководство пользователя

Страница: 72 / 294

Managing the Encoder
Configuring the Video Settings
Makito User’s Guide, v2.1.0, Issue 01 72
2.
Select or enter the new value(s) in the appropriate field(s). See the following section,
“Video Settings” .
3.
To apply your changes, click .
The changes will take effect immediately but will not be saved and will be lost after a
reboot
.
TIP
To save the current configuration, open the
A
DMINISTRATION
>C
ONFIG
page. See
“Saving and Loading Configurations” on page 126.
Video Settings
The following table lists the Encoder Video settings:
Video Setting Default Description/Values
Input Select the type of Video Input for the
encoder:
Makito Digital
(HDMI/DVI)
• Analog (Component/RGB)
• Digital (HDMI/DVI)
Makito-SDI BNC (SDI) • BNC (SDI)
• BNC (Composite)
• S-Video
NOTE:
Only one physical connector can be
selected as the video source.
If you select an inapplicable Input type, the
Input Format becomes
Unknown
, since this
is auto-detected by the system.
Input Format
n/a This is the input signal detected from the
video source. It includes the number of pixels
per line, whether the video is interlaced or
progressively scanned (indicated by
i
or
p
),
and the number of frames per second: either
25
or
30
for interlaced, or
50
or
60
for
progressively scanned.
This is auto-detected by the system and
cannot be changed. If the signal cannot be
detected (or is outside the supported range),
the Input Format will be
Unknown
.