vario flex
Installation
32
Order h49 7144.907-333
D
Clamping ring
E
Adapter disc
1. As described in the »Preparation of the machine for in-
stallation« chapter, prepare for the following steps.
7.5.1 Compatibility check
Check the compatibility of the product and the connection
point of the clamping device.
For this, check that the connection point and the product
share the same adaptation geometry. Also check if the actu-
ating element / coupling element is suitable.
7.5.2 Preparation of the product
The following preparatory steps are needed to install the
product.
If the product is to be used as an ejector, the following pre-
paratory steps are needed to install the product.
1. Unfasten the clamping nut and unscrew it approximately
4 mm.
2. Clean the gas pressure spring housing with a soft cloth
to remove residues of oil, grease and dirt.
3. Install the gas pressure springs with the piston rod fac-
ing the adapter disc firmly home in the bore.
