Quick change-over system centroteX M
Use and limits of use
26
Order h49 7144.907-333
5 Use and limits of use
5.1 Use
The product serves only to support HAINBUCH quick
change-over units / quick change-over adapters on chip-
cutting machine tools.
The product can only be used in combination with a suitable
quick change-over unit / a suitable quick change-over
adapter from HAINBUCH.
As well as for its general field of application, this product
was designed and developed for use, when necessary, in a
specific and documented application [see clamping situa-
tion drawing or order confirmation].
Any other fields of application require the explicit approval
of the manufacturer.
5.2 Limits of use
The permitted transmissible torque on the quick change-over
system is determined by the screw connection between ma-
chine adapter and quick change-over adapter.
WARNING
Serious injuries caused by accidental opening of
the quick change-over system when the maximum
transmissible torque limit is exceeded!
Never exceed the maximum transmissible torque
on the quick change-over system.
The maximum permitted transmissible torque is written on
the machine adapter or can be found in the following table,
and must not be exceeded.
Screw connection
at the interface
Tightening torque
[Nm]
Maximum trans-
missible torque
[Nm]
3 x M8
25
215
6 x M8
25
430
3 x M10
50
750
6 x M10
50
1500
6 x M12
100
2200
6 x M16
220
4500
6 x M20 x 1.5
220
5000
Table 3:
Maximum transmissible torque
