Maintenance
1.
Turn off the water tap and pull out electricity plug after each wash. Open the porthole
to prevent formation of moisture and odors. If the washing machine is left idle for a
long period, drain the water in the machine and replace the drainage hose.
2. Unplug the machine during cleaning and maintenance. Use a soft cloth dampened
with soap liquid to clean the machine case and rubber components. Do not use corrosive or
abrasive chemicals or solvents.
3. Clean the detergent distribution drawer regularly.
For the detergent distribution drawer similar to Figure (a), swing out the drawer and
raise slightly to remove and replace after cleaning.
4. To prevent blockage to the water supply by ingress of foreign substances, clean the
water inlet and inlet filter regularly.
5. Clean the filter (once a month)
1)
Pull directly the outer cover out with both hands (Figure 2);
2)
Remove the filter by turning counterclockwise;
3)
Flash clean with running water;
4)
Replace the filter by turning clockwise and remount the cover.
Caution: The cover and the body fit tightly to ensure safe transportation. It
will be difficult to remove the cover for the first one or two times. Use a flat
screwdriver to slightly loosen the cover from both sides (Figure 4), then
remove the cover (Figure 5).
Remove the back
cover and take out
the three rubber
plugs.
Insert the channel
steel vibration locks
and the bolts.
Insert the rubber bolt
gaskets.
6. If the machine is to be moved
to a distant place, replace the
vibration absorbing
locks
(packing screws, rubber gaskets)
removed before installation to
prevent damage as shown below.
Tighten the bolts with the
spanner provided.
Replace the back cover.
7.
If the washing machine is left idle for a long
period, pull out the electrical
plug and turn off the water tap. Open the door to prevent formation of moisture and
odors. Let the door open while not used.