As shown in figure1 remove all the packing materials
(including the foam base).
Fig 1
Check attachments and materials.
3
Name
Operational
manual
Quality
certificate
Water
hose
Drainage
holder
Plastic
plugs
1
1
1
Qty
2
Distribu-
tion box
1
==
Remove the packing screws as shown in figure 2.
The packing bolts protect the appliance from shock during trans-
portation The steps below should be followed before using the
appliance,
1. Remove the back plate of the washing machine;
2. Remove the three packing bolts and the rubber houses from the
rear panel of the washing machine;
3. Reinstall the back plate;
4. Fill the holes left by the packing bolts with plastic plugs.
(Attention: the packing bolts and rubber hose should be kept in a
safe place for later use)
===
Adjusting the position of the washing machine .There are ad-
justable feet under the bottom of the washing machine. Before use,
the washing machine should be adjusted, as shown in figure 3, so
that it is level.
cáÖ=O
cáÖ=P
4
Installation
The following circumstances do not constitute problems. Do not contact the
maintenance service until the problem has been confirmed.
Problem
Possible Cause
The washing machine fails to
operate
Poor connection to power supply
Power failure
Door is not properly closed
Machine has not been switched on
Washing machine does not fill
with water
Water is not turned on
Water pressure is less than 0.05MPa
The inlet hose is kinked
Water supply failure
The program knob is not properly set
The door is not properly closed
The water supply and
drainage do not stop
==
Check that the height of the water hose is below
80cm
Drainage failure
=
Drainage hose is blocked
=
Drainage hose end is below 100cm above the
floor level
Excessive foam in the drum
=
The detergent is not a low foam type
Excessive detergent has been used
Operation stops before comple-
tion of the wash cycle
Water or electricity failure
Strong vibration during spin
==
Some packing fixing bolts removed
Washing machine on a uneven surface
Trouble shooting
13
