ECO Button
This button (see "close-up View - Control Panel", letter "B") is
used in the normally dirty dishes, pots and pans. It is standard
daily cycle.
Starting the Appliance
Starting a wash cycle ... ...
- Make sure that the plug for the appliance is inserted into the
wall socket.
- Make sure that the water supply is turned on to full pressure.
- Load the dishwasher (see the section entitled, "Loading the
Dishwasher").
- Pour in the detergent (see the section entitled, "Salt, Dergent
and Rinse Aid").
- Turn the knob located on the right of the control panel in the
clockwise direction until the number or symbol for the cycle sec
tion entitled, "Wash Cycle Table").
- Press the ON-OFF button, and the ON-OFF light will turn on.
At this point, the wash cycle will begin.
Cancelling or modifying a wash cycle setting
Press the ON-OFF button and the ON Light will turn off. Rotate
the knob in the clochwise direction to the desired cycle setting
(see the section entiled, "Starting a wash cycle...").Then, turn
the dishwasher back on using the ON-OFF button.
At the end of the wash cycle ... ...
When the knob stops turning and is aligned with a STOP mark
(see figure), the cycle has finished. Turn off the appliance using
the ON-OFF button, turn off the water supply and open the door
of the dishwasher.
Wait a few minutes before unloading the dishwasher to avoid
handling the dishes and utensils while they are still hot and more
susceptible to breakage. They will also dry better.
Wash Cycle adjustment Buttons
1/2 load Button
This button (see "close-up View - Control Panel", letter "C") make
it possible to wash dishes using only the upper rack if there are
not enough dishes for a full load. This will allow you to save on
water and electrical energy.
.6.
GB
STOP
